Annealing temperature effect on residual stresses in 316L steel subjected to HPT process
|Anna Drużycka-Wiencek 1, Tomasz Wejrzanowski 1, Krzysztof J. Kurzydlowski|
1. Warsaw University of Technology, Faculty of Materials Science and Engineering (InMat), Wołoska 141, Warszawa 02-507, Poland
The paper describes results of the studies curried out on specimens of nano-316L steel obtained by severe plastic deformation (SPD). Specimens were prepped by High Pressure Torsion (HPT) and cold rolling. Size of grains in SPD-316L was determined by TEM observations. Residual stress and microhardness have been measured for as deformed and additionally annealed samples. The results are discussed in terms of the combined effect of grain size refinement and residual stress on the properties of nano-ausenitic stainless steel.
Presentation: poster at E-MRS Fall Meeting 2004, Symposium I, by Anna Drużycka-Wiencek
See On-line Journal of E-MRS Fall Meeting 2004
Submitted: 2004-05-13 14:10 Revised: 2009-06-08 12:55
|© 1998-2018 pielaszek research, all rights reserved||Powered by the Conference Engine|